Structura MA was created to combine lightweight properties with mechanical strenght. The addition of carbon fibers allows the production of structural supports with more advanced geometries and by overcoming more constructive challenges than ever before.
100% skin contact approved
STRUCTURA MA is idel for:
- limb prosthetics
- mobility support
- exoskeletal elements
PCPBT has the typical characteristics of polycarbonate (impact resistance, for example) and PBT (good lubrication)
Impact resistant, Resistant to chemical aggression, Dimensional stability guaranteed
Applications: internal bumper, car bumpers, sensor bodies
The printer must have the performance to meet the PEEK filament and it should be printed with a nozzle temperature of 360 - 400°C.
The heat bed should be set to 120°C and 3D Printer need to have heated chamber. It's also very important to make sure that the printer is placed in a room where there's hardly any draft and temperature fluctuations.
PEEK is best printed on a PEI sheet at a printing speed of 15-30 mm/s.
Ideal for: PEI, PEEK, PPS, all HT product over 300 °C
MAGIGOO HT is designed for professional use, to work at high printing temperatures. The part should be relatively easy to remove once it cools and the glue residue should also be easily cleaned off.
High-temperature filaments prove to be challenging materials for FDM printing due to their higher tendency to warp. These materials are generally printed at elevated temperatures owing to their high-temperature properties. MAGIGOO HT is a specialized solution for FDM printing of PEEK filaments which was developed to work at elevated printing temperatures.
HOW TO USE IT:
MAGIGOO HT has been designed and tested to work with build-plate temperature of 150 °C or lower.
• Shake the bottle.
• Apply to the desired area by pressing the nib on the bed (activating the inner valve) and spreading as needed.
• Print according to the filament/printer manufacturers recommendations
• Allow to cool and remove. The print should pop right off
• Clean - Use a damp cloth to wipe off.
Using this product with other than PEEK filaments might cause over adhesion and damage your build surface. Follow the instructions found in the technical data sheet for the best results.
For larger prints, a 20 mm brim is recommended.
Magigoo HT was designed for glass surface but also works on high-temperature garolite and other build-surfaces.