PP - Polypropylene

Ideal for: TPE , PP

MAGIGOO PP is designed for professional use, to work exclusively with polypropylene filaments. The part should be relatively easy to remove once it cools and the glue residue should also be easily cleaned off if the included procedure is followed.

HOW TO USE IT?
MAGIGOO PP has been designed and tested to work with different PP filament brands.
• Shake the bottle vigorously.
• Apply to the desired area by pressing the nib on the bed (activating the inner valve) and spreading as needed.
• Print according to the filament/printer manufacturers recommendations
• Allow to cool and Remove – The Part should become easier to remove after sufficient cooling. If the part is hard to remove, a scraper should be used to assist part removal.
• Clean - Use a wet hard sponge to remove all glue residue. Once the glue layer is wet it will form a white layer which can be easily scrubbed off with an abrasive sponge. Once the layer is completely loose from the glass it can be wiped away with a wet cloth and finally cleaned with a dry paper towel.

SAFETY:
This adhesive is for professional use. Contact with eyes causes serious eye damage, Wash hands and exposed skin thoroughly after handling.

Tips:
For larger prints a 20 mm brim with multiple layers is recommended
In cases of excess adhesion, it is recommended to wet print bed with a small amount of water slowly work it below the part, this should make part removal easier